| 12volts |
red (40A), red (40A) |
+ |
ignition harness |
| Starter |
yellow |
+ |
ignition harness |
| Second
Starter |
N/A |
|
|
| Ignition |
pink |
+ |
ignition harness |
| Second
Ignition |
white |
+ |
ignition harness |
| Notes: To avoid the check engine light
from coming on and possible damage to the automatic transmission,
the second ignition in this vehicle MUST be powered when adding a
remote start system. |
| Third
Ignition |
N/A |
|
|
| Accessory |
orange |
+ |
ignition harness |
| Second
Accessory |
brown |
+ |
ignition harness |
| Keysense |
lt. green |
- |
ignition harness |
| Power
Lock |
use 457G or 456G module |
|
|
Notes: If Directed module 457G or 456G is
not available, refer to DirectFax document 1601.
On base
model trucks, the 457G or 456G is not necessary. Instead, the lock
wire is lt. blue (-), pin B5, and the unlock wire is white (-), pin
B10. They are in the lt. blue plug at the BCM. |
| Power
Unlock |
see power lock |
|
|
| Lock
Motor |
gray |
5wi |
driver door module in door |
| Unlock
Motor |
tan |
5wi |
driver door module in door |
| Parking
Lights+ |
brown |
+ |
driver kick panel |
| Parking
Lights- |
gray/black |
- |
switch or BCM, brown plug, pin B2 |
| Notes: The BCM (Body Control Module) is
under the driver side dash. It has 6 plugs in it, the purple plug is
on the back. |
| Hazards |
white |
- |
hazard switch |
| Turn Signal(L) |
dk. green |
+ |
turn signal switch |
| Turn Signal(R) |
lt. green |
+ |
turn signal switch |
| Reverse Light |
lt. green |
+ |
BCM, black plug, pin F |
| Notes: The BCM (Body Control Module) is
under the driver side dash. It has 6 plugs in it, the purple plug is
on the back. |
| Door
Trigger |
gray/blk (L), black/wht (R) |
- |
each door module in each door |
Notes: On base model trucks, the door
trigger wires are in the lt. blue plug at the BCM, pins B4 and
A5.
On 4dr trucks, the LR door trigger is lt. blue/black, pin
A3, and the RR is lt. green/black, pin A2. They are in the purple
plug at the BCM.
Use all wires and diode isolate.
The
BCM (Body Control Module) is under the driver side dash. It has 6
plugs in it, the purple plug is on the back. |
| Dome
Supervision |
gray/black |
+ |
BCM, black plug, pin E |
| Notes: The BCM (Body Control Module) is
under the driver side dash. It has 6 plugs in it, the purple plug is
on the back. |
| Trunk/Hatch
Pin |
N/A |
|
|
| Hood
Pin |
N/A |
|
|
| Trunk/Hatch
Release |
N/A |
|
|
| Power Sliding Door |
N/A |
|
|
| Factory
Alarm Arm |
arms on lock with door open |
|
|
| Factory
Alarm Disarm |
lt. green |
- |
driver door module in door |
| Disarm
No Unlock |
see factory alarm disarm |
|
|
| Tachometer |
white |
ac |
instrument cluster, pin A5 or PCM
|
Notes: The PCM (Powertrain Control Module)
is in the left front of the engine compartment to the left of the
fan shroud.
On gas models, the tach wire is in the green
plug, pin 10.
On diesel models, the tach wire is in the gray
plug, pin 37.
On hybrid models, the tach wire is in the green
plug, pin 35.
For tach can also go to any of the ignition
coils or fuel injectors and use the wire that is NOT pink, black, or
brown. |
| Wait to start |
dk. blue |
- |
instrument cluster, pin A2 or PCM
|
| Notes: The PCM (Powertrain Control Module)
is in the left front of the engine compartment to the left of the
fan shroud. The wait to start wire is in the blue plug, pin
26. |
| Brake
Wire |
white |
+ |
brake pedal switch |
| Parking Brake |
lt. blue |
- |
switch or BCM, lt. blu plug, pin A7
|
| Notes: The BCM (Body Control Module) is
under the driver side dash. It has 6 plugs in it, the purple plug is
on the back. |
| Horn
Trigger |
black/yellow to black |
- |
switch or BCM, gray plug, pin B9
|
| Notes: The BCM (Body Control Module) is
under the driver side dash. It has 6 plugs in it, the purple plug is
on the back. |
| Memory Seat 1 |
red |
+ |
driver door module in door |
| Memory Seat 2 |
pink |
+ |
driver door module in door |
| Memory Seat 3 |
N/A |
+ |
| 
| Interface Module: |
Category:
Immobilizer
Bypass |
Required:
Yes |
Type:
Passlock II |
| Part #: 556LW |
| Alternate Part1 #: 555T |
| Alternate Part2 #: DesignTech
20402 |
| Alternate Part3 #: DesignTech
29402 |
| Alternate Part4 #: 555LW |
Notes: Not required if using
the combo interface module.
The Passlock II wire colors are
yellow, black, and red/white (not used). |
| Interface Module: |
Category:
Door Lock
Interface |
Required:
Yes |
Type:
Data Bus |
| Part #: 456G |
| Notes: Not required if using
the combo interface module. |
| Interface Module: |
Category:
Combo
Interface |
Required:
Yes |
Type:
Data Bus |
| Part #: 457GW |
| Notes:
|
 This wiring
information is being provided free of charge on an "as is" basis,
without any representation or warranty. It is your responsibility to
verify any circuit before interfacing with it using a digital
multimeter.
Directed electronics, Inc. assumes no responsibility
with regards to the accuracy or currency of this information. Proper
installation in every case is and remains the responsibility of the
installer. DEI assumes no liability or responsibility resulting from
improper installation, even in reliance upon this information.
|
|