| 12volts |
red (x2) |
+ |
ignition harness |
| Ignition |
pink |
+ |
ignition harness |
| Parking
Lights+ |
brown |
+ |
driver kick panel |
| Parking
Lights- |
gray/black |
- |
BCM, brown plug, pin B2 |
| Notes: The BCM (Body Control Module) is
under the driver side dash. It has 6 plugs in it, the purple plug is
on the back. |
| Headlight |
white |
- |
BCM, lt. blue plug, pin A12 |
| Notes: The BCM (Body Control Module) is
under the driver side dash. It has 6 plugs in it, the purple plug is
on the back. |
| Trunk/Hatch
Release |
N/A |
|
|
| Power Sliding Door |
N/A |
|
|
| Speed Sense |
dk. green/white |
4K |
instrument cluster, pin A4 or PCM
|
| Notes: The PCM (Powertrain Control Module)
is in the left front of the engine compartment to the left of the
fan shroud. The VSS wire is in the green plug, pin 50. |
| Wipers |
pink (L), dk. blue/white (H) |
- |
steering column |
| LF Window up/dn |
dk. blue - brown |
C |
driver door module in door |
| RF Window up/dn |
dk. blue - brown |
C |
passenger door module in door |
| LR Window up/dn |
dk. blue - brown |
C |
LR window switch in door |
| RR Window up/dn |
dk. blue - brown |
C |
RR window switch in door |
| Sun
Roof open/close |
N/A |
|
|
| Sun
Roof Limit/close |
N/A |
|
|
| Memory Seat 1 |
red |
+ |
driver door module in door |
| Memory Seat 2 |
pink |
+ |
driver door module in door |
| Memory Seat 3 |
N/A |
+ |
| 
| Interface Module: |
Category:
Immobilizer
Bypass |
Required:
Yes |
Type:
Passlock II |
| Part #: 556LW |
| Alternate Part1 #: 555T |
| Alternate Part2 #: DesignTech
20402 |
| Alternate Part3 #: DesignTech
29402 |
| Alternate Part4 #: 555LW |
Notes: Not required if using
the combo interface module.
The Passlock II wire colors are
yellow, black, and red/white (not used). |
| Interface Module: |
Category:
Door Lock
Interface |
Required:
Yes |
Type:
Data Bus |
| Part #: 456G |
| Notes: Not required if using
the combo interface module. |
| Interface Module: |
Category:
Combo
Interface |
Required:
Yes |
Type:
Data Bus |
| Part #: 457GW |
| Notes:
|
 This wiring
information is being provided free of charge on an "as is" basis,
without any representation or warranty. It is your responsibility to
verify any circuit before interfacing with it using a digital
multimeter.
Directed electronics, Inc. assumes no responsibility
with regards to the accuracy or currency of this information. Proper
installation in every case is and remains the responsibility of the
installer. DEI assumes no liability or responsibility resulting from
improper installation, even in reliance upon this information.
|
|